Replacement Banner Graphic - Cobra

Our Cobra replacement graphics are printed onto a 510gsm tear-resistant fire-rated blockout PVC which means you will not be able to see a shadow of the pole through the graphic. We use a UV flatbed printer so the inks won't fade or run and our inks don't contain VOCs which are harmful to the environment. 

If you return your existing cobra banner stand graphics to us we can remove the old rails and attach them to the new graphics. If you wish to keep your old graphics aswell, please be sure to tell us.

Artwork Requirements - design templates are also available in our download section below

Size:800mm wide x 2100mm page size.

Resolution:We suggest no less than 150dpi at full size. Please increase resolution accordingly to allow for any enlargement should you set artwork at a reduced-scale.

Colour Mode:Supply artwork in CMYK mode only

Important Info:Please note that the gripper rails at the top and bottom of the stand will cover the graphic by 1cm so make sure there is nothing you wish to be seen at the extreme top or bottom.

Files types supported: Please save files as JPG, Tiff or PDF

Optional graphic storage tubes are available under the accessories tab